Easy and Affordable DIY Round Jute Place Mats
Hello everyone, Happy Monday! It’s that time of the week again and I am so excited to share with you my Jute Place mats project. These place mats add the perfect farmhouse touch and make our dining room look so homey. They were very simple to make and don’t require much of anything.
You can find very similar place mats like these at places such as pottery barn, but you will end up spending a lottt more money. Before I decided to make them myself I had been on the lookout for quite some time. But I was never able to find affordable ones that had the color and texture of rope that I was looking for. Most of them were very stiff and not as easy on the eyes. The Craft rope that I used for these produced exactly what I was looking for!
Here is a list of everything I used to make 6 - 13" diameter placemats:
- 9 – Fab lab 1/4″ Jute craft rope 25′ long*
- Glue gun
- Plenty of glue sticks
- 6- old round 13″ place mats or bottom of choice
*Each place mat uses 1-1/2 packages of the Fab lab craft rope (approximately 37′ each).
Step 1:
Plug your glue gun in and get it nice and hot. It shouldn’t take longer than a few minutes.
While you wait for it to heat up cut one of the packages of the craft rope in half and put aside, we will come back to this in step 3. Next, Grab your bottom of choice. This can be an old round place mat or a 13″ round of another fabric. Either will work as your base and will help guide you.
Note: You can do this project without using a bottom piece, it is just a lot harder to hide the glue mess and takes longer. I tried it both ways just to test it out and found that it is a lot easier with the bottom. Plus, your place mat is more likely to stay together and come out flat, when being glued down to the bottom.
Step 2:
Put glue on the end of your rope and place it in the very middle. Once you have that glued down you will start to wrap the rope around as you glue it. I applied the glue directly to the bottom place mat and some to the side of the rope I was wrapping it against to ensure that all sides were glued down. Continue doing this until the first package of rope is done. Make sure to press the rope down on the hot glue as you wrap it around to ensure a maximum hold and that there are no gaps. The glue dries very quickly, so keep this in mind when you are laying the glue.
PS: The glue is also very hot, so beware. I know that is common sense but my fingers suffered quite a bit with this project because I’m very impatient and was going too fast haha.
Step 3:
Now it is time to attach the rope that you cut in step 1 to what you have started. Place glue on the end of the rope attached to the bottom piece and on the bottom where the rope will rest. Once you have done this just glue down the rest until you are done.
Step 4:
Follow steps 1-3 on the other 5 place mats! Pretty simple! If you used a place mat bigger than 13″ for your bottom you can just trim off the excess!
I hope you enjoyed my DIY Jute place mats! Make sure to subscribe so that you don’t miss out on my future DIY Endeavors!
If you decide to try this out make sure to comment below, I would love to hear from you! You can also pin this to try later!
I hope that your week is off to a great start!
4 Comments
Angie
Where did you get the vase? I love it!
Steph Read
Sadly I got it from Home Goods so I wasn’t able to find a link for it! But if you found a vase that you liked you could easily add some jute rope around the neck of it for a similar look 🙂
Neetaka
Love the vase!! What kind on plant is in it please? You did a fantastic job. Going to try this project next. The pic is my inspiration for my kitchen make over.
Steph Read
Thank you so much! They are eucalyptus stems that I purchased from Amazon! Here is the link for the ones I purhased: https://rstyle.me/+Jiv-tN7ze_vfolLRcNoqmw